Skip to content
Meridian Plumbing Service

Faucets and fixtures

Faucet and fixture repair

Small problems, but they waste water and get worse. Each fixture has its own shut-off or shares one close by.

Common fixture problems

  • Dripping when it is shut. Inside the handle, a rubber washer or a plastic cartridge has worn. Each faucet maker uses its own cartridge shapes, so take a photo of the faucet and any name on it before the visit.
  • Low flow at one faucet only. A scaled-up aerator. Unscrew it from the tip and soak it in vinegar.
  • Water under the kitchen sink when the faucet runs. A leaking sprayer hose or a loose connection under the deck.
  • A shower that turns cold when someone flushes. An older valve without pressure balancing, or a worn balancing cartridge.
  • A tub spout that keeps running when the shower is on. The diverter is worn.

Replacing a faucet

The old faucet comes off, the sink deck is cleaned of scale and old sealant, and the new one goes on with new supply lines. If the shut-off valves under the sink are stiff or weep, this is a good time to replace them too.

  • Is a new cartridge enough here, or is this faucet too old to rebuild?
  • The little valves under my sink are stiff. Should they be swapped during this visit?
  • I bought a faucet already. Will you fit one I supply, and does that change the price?

Hard water and fixtures

Meridian's hard water leaves scale inside cartridges and shower valves as well as on the outside. A cartridge that has grown stiff or gritty to turn is often scaled up; the plumber may clean it, but on an old valve a replacement part usually lasts longer. Shower heads and aerators can be soaked clear between visits.

Call (208) 555-0135