Skip to content
Meridian Plumbing Service

Leaks

Leak detection and leak repair

Some leaks announce themselves with a drip. Others show up as a stain, a smell, or a water bill that does not fit.

Check for a hidden leak with the meter

  1. Turn off every tap, and make sure the washer, dishwasher, softener and ice maker are not running.
  2. Find the water meter, usually in a box near the street or sidewalk, and note the reading or watch the small leak indicator.
  3. Wait half an hour without using water. If the numbers moved, water is going somewhere.

Then close the main shut-off in the house and look again. If the meter still moves, the leak is between the meter and the house, in the buried service line.

Where leaks usually are

Easy to find

  • Under sinks: supply hoses and the trap
  • Behind the toilet: the fill valve and supply
  • At the water heater's fittings
  • The softener's drain line

Hard to find

  • Inside a wall behind a shower valve
  • In the ceiling under an upstairs bathroom
  • Under a slab or in the yard
  • A toilet that leaks into the tank only, shown by dye

How a plumber traces a leak

  1. Isolate

    Valves are closed one at a time to see which branch is losing pressure.

  2. Listen and measure

    Acoustic listening, moisture meters and thermal cameras narrow where to open up.

  3. Open as little as possible

    A small cut in drywall or ceiling at the wet spot, not a whole wall.

  4. Repair the section

    A new fitting or length of pipe, then the line is put back under pressure and watched.

Drying out afterwards

The plumber fixes the pipe. Wet drywall, insulation and flooring under a long leak usually need drying or removal by someone else. Take photos before anything is cut, for the insurer.

  • How much wall or ceiling will you open, and who patches it?
  • Is the leak at a fitting or is the pipe itself failing in other places too?
  • If the leak is in the buried service line, is that my side of the meter?
Call (208) 555-0135