Skip to content
Meridian Plumbing Service

Water heaters

Water heater repair and replacement in Meridian

A water heater is the biggest plumbing job most Meridian houses ever need. This page covers a tank that leaks, a heater that stopped heating, tankless units, and what a replacement involves, so the conversation with the plumber is shorter.

What the heater is telling you

  • No hot water at all. On gas, the pilot or igniter may have failed; on electric, a tripped breaker or a burned-out element.
  • Hot water runs out quickly. Often a broken dip tube or a thick layer of scale and sediment taking up the bottom of the tank.
  • Popping or rumbling while it heats. Water trapped under sediment boils in bursts. Meridian's hard well water makes this common.
  • Rusty hot water, cold side clear. The tank lining may be failing from the inside.
  • A sulfur smell only from the hot taps. Usually a reaction at the anode rod, which a plumber can swap for a different type.
  • A slow drip from the tank body or a wet ring under it. The tank itself is leaking. That cannot be patched.

Inside a tank heater

Cold shut-offHot outDip tubeAnode rodRelief valveDischarge pipeScale and sedimentGas control
A gas tank heater cut open. Cold water goes down the dip tube to the bottom, the burner heats it, and hot water leaves from the top. Scale settles on the floor of the tank; the anode rod wears away so the steel does not.

Repair it or replace it?

The age on the label and where the water is coming from decide most of this.

Usually worth repairing

  • A thermocouple, flame sensor or igniter on a gas unit
  • A heating element or thermostat on an electric unit
  • The relief valve, or a leaking fitting on the pipes above the tank
  • A worn anode rod, if the tank is not leaking

Usually time to replace

  • Water leaking from the tank body or seeping from under the jacket
  • Rust in the hot water from a tank well into its second decade
  • Repeated part failures on an older unit
  • A gas control valve failure on an old tank, where the part is a large share of a new heater

Tank or tankless

Another tank

The simplest swap: same spot, same connections, often the same venting. Size it to the household. A bigger tank than before means checking the space and the vent.

A tankless unit

Heats water as it flows, so it does not run out, but it needs the right gas line size or electrical supply and its own venting. With hard water it needs scale removal on a schedule, and many installers suggest a softener or scale filter ahead of it.

How a replacement usually goes

  1. Shut down and drain

    Water, gas or power off; the old tank is drained through a hose to a floor drain or outside.

  2. Out with the old one

    Disconnected and carried out. Ask whether hauling it away is part of the price.

  3. Set and connect

    New heater placed, water lines and the relief valve discharge pipe connected, gas and vent or wiring hooked up.

  4. Fill, then fire

    The tank is filled before gas or power is turned on, then checked for leaks and for the burner or elements working.

  5. Permit and inspection

    Idaho requires a permit for plumbing work. Ask who pulls it and when the inspection will be.

Permits for a water heater in Meridian

Idaho's plumbing program says a permit is required when plumbing work is done (DOPL plumbing questions). The City of Meridian issues its own plumbing permits, and its permit list includes a water heater type. The plumber should know which office covers your address and pull the permit before the work.

A permit means an inspector looks at the gas connection, venting and relief valve piping. That is the part of the job you cannot easily check yourself.

Ask before you agree to a new heater

  • Is the price for the heater installed, permit and haul-away included?
  • Does the gas line, vent or electrical need changing for this model?
  • Who registers the manufacturer's warranty, and what does it cover?
  • How often should this heater be flushed or descaled with our water?
  • What is your Idaho plumbing contractor licence number?

Water heater questions

Can I take a shower while the heater is off?

Only a cold one. Once the cold-water valve to the heater is closed, the rest of the house still has cold water.

Why does my heater make noise more than my old house's did?

Hard water leaves more scale. Flushing the tank on the schedule in its manual helps; a heater that already rumbles loudly may have a thick layer.

Is a leaking relief valve dangerous?

It is doing its job of letting off pressure or heat. Do not plug or cap it. Tell the plumber, because the cause needs finding.

Call (208) 555-0135